PRODUCTS CENTER

Permanent Anti-stain&anti-slip pavement marking tapes (Particles Surface)

Permanent Anti-stain&anti-slip pavement marking tapes (Particles Surface)

Preformed Permanent Anti-stain&anti-slip pavement marking tapes are a new type of material that features a special anti-slip layer on its surface, providing excellent skid resistance while being easy to clean. It does not contain glass beads on the surface and is composed of flexible polymer materials and other ingredients.

关键词:

Temporary pre-formed line striping

电话

Product details

Product Information

Brand: Color Road
Color: white, yellow, red, blue, black, green


Product Features

--Preformed reflective marking tape, which can be made into any specification according to customer requirements.

--The preformed material substrate is composed of polymer flexible polymer rubber, fillers, pigments, etc., and a layer of high wear-resistant environmental protection paint and anti-skid particles are planted on the surface. It has anti-fouling and anti-skid, strong wear resistance, good weather resistance, and durability. Long life, convenient and fast construction, and so on.

--Applicable to concrete, asphalt, cement, marble, and other road surfaces and walls of various materials. Widely used in railway stations, bus stations, shopping malls, hotels, hotels, hospitals, schools, playgrounds, factories, workshops, canteens, warehouses, etc.

--Can be made into various marking lines, arrows, words, patterns, colored sign markings on road surfaces, colored three-dimensional signs, and pipeline signs.

--Depending on the condition of the road surface, traffic flow, and installation, the service life can be at least 2 years.


Product size reference chart

Product number Standard Length(m) Standard Width(cm) Thickness(mm) Weight(±10%) Conventional packaging Adhesive
L-40X 40M 5,10,15,20, within 100 customizable 1.2MM 2.2kg/sqm 300*300*320MM without adhesive backing
L-41X 40M 5,10,15,20, within 100 customizable 1.4MM 2.4kg/sqm 300*300*320MM with adhesive backing

Technical Parameters

      Properties

Typical data

unit

Test Methods

________

________

color

white

yellow

________

________

thickness

1.2

1.2

mm

GB/T 7125

water resistance

pass

pass

________

GB/ T24717

acid resistance

pass

pass

________

GB/T 24717

Wear-resistant

40

40

mg

GB/T24717

minimum adhesion

25

25

N/25mm

GB/T24717

Anti-skid value

>45;>55

>45;>55

BPN

GB/T24717

Instructions:

1. The pavement marking tape without adhesive backing is commonly used in special environments and special materials, using special glue, such as two-component AB glue, 502 glue, etc.


2. The products with adhesive backing can be divided into ground brush primer and ground primer without brush according to the usage:

  • Without brush primer on the ground: It can be directly applied to smooth and flat surfaces without applying primer when used indoors, on outer pavement, and various walls of place such as workshops, exhibition halls, squares, safety islands of toll stations, where few vehicles run over, it only needs rip off the isolated paper on the back of the product and sticks it directly to the joint surface. And its life can be 5 years to the longest.
  • Brush primer on the ground: It should be applied with primer on uneven surfaces or walls(e.g., Pattex Contact Adhesive, Maxbond UL 1603HFR-HS). The amount of primer required depends on the smoothness of the bonding surface, approximately 1 kilogram per 3 to 5 square meters. Please refer to the construction instructions when using the primer.

Prev: None

Next: None

Online
Message


If you have any suggestions or feedback about our company, please fill in the relevant information on this page and submit it. Our staff will contact you in a timely manner, or please call us directly.

电话

Submit